Look at the Octagon SF4008. This is an unsupported receiver from the manufacturer, but it is a cheap twin dvb-s/s2 tuner receiver with internal hard drive and advertises a gigabit port.
this means no openpli? no i want openpli
Posted 19 December 2021 - 23:04
Qviart DUAL 4K UHD ?
Virtually identical to the SF8008, and advertised with gigabit?
edit:
root@dual:~# ethtool eth0 Settings for eth0: Supported ports: [ TP AUI BNC MII FIBRE ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Supported pause frame use: No Supports auto-negotiation: Yes Supported FEC modes: Not reported Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Advertised pause frame use: No Advertised auto-negotiation: Yes Advertised FEC modes: Not reported Speed: Unknown! Duplex: Unknown! (255) Port: MII PHYAD: 3 Transceiver: external Auto-negotiation: on Supports Wake-on: ug Wake-on: d Current message level: 0x00000007 (7) drv probe link Link detected: no
No internal disk though.
Edited by WanWizard, 19 December 2021 - 23:08.
Currently in use: VU+ Duo 4K (2xFBC S2), VU+ Solo 4K (1xFBC S2), uClan Usytm 4K Ultimate (S2+T2), Octagon SF8008 (S2+T2), Zgemma H9.2H (S2+T2)
Due to my bad health, I will not be very active at times and may be slow to respond. I will not read the forum or PM on a regular basis.
Many answers to your question can be found in our new and improved wiki.
Posted 19 December 2021 - 23:32
Qviart DUAL 4K UHD ?
Virtually identical to the SF8008, and advertised with gigabit?
edit:
root@dual:~# ethtool eth0 Settings for eth0: Supported ports: [ TP AUI BNC MII FIBRE ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Supported pause frame use: No Supports auto-negotiation: Yes Supported FEC modes: Not reported Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Advertised pause frame use: No Advertised auto-negotiation: Yes Advertised FEC modes: Not reported Speed: Unknown! Duplex: Unknown! (255) Port: MII PHYAD: 3 Transceiver: external Auto-negotiation: on Supports Wake-on: ug Wake-on: d Current message level: 0x00000007 (7) drv probe link Link detected: noNo internal disk though.
seems single sat? no twin?
Posted 19 December 2021 - 23:34
No, it's a S+C/T box.
Currently in use: VU+ Duo 4K (2xFBC S2), VU+ Solo 4K (1xFBC S2), uClan Usytm 4K Ultimate (S2+T2), Octagon SF8008 (S2+T2), Zgemma H9.2H (S2+T2)
Due to my bad health, I will not be very active at times and may be slow to respond. I will not read the forum or PM on a regular basis.
Many answers to your question can be found in our new and improved wiki.
Posted 20 December 2021 - 02:04
Posted 20 December 2021 - 14:32
look at the AB-Com PULSe 4K I am really happy with this one too.
looks nice but 10/100 Mbps no gigabit?
one page says 10/100 other says 10/100/1000? what is it?
and possible hdd internal? or only external?
Both internal and extenal (via USB).
1000 for Ethernet on a STB doesn't means that you will effectively be able to use the full bandwidth the STB SoC is always limited on its bus and Gigabit remains a sale argument, even 100 ethernet cannot always be fully used.
NO SUPPORT by PM, it is a forum make your question public so everybody can benefit from the question/answer.
If you think that my answer helps you, you can press the up arrow in bottom right of the answer.
Wanna help with OpenPLi Translation? Please read our Wiki Information for translators
Sat: Hotbird 13.0E, Astra 19.2E, Eutelsat5A 5.0W
VU+ Solo 4K: 2*DVB-S2 + 2*DVB-C/T/T2 (used in DVB-C) & Duo 4K: 2*DVB-S2X + DVB-C (FBC)
AB-Com: PULSe 4K 1*DVB-S2X (+ DVB-C/T/T2)
Edision OS Mio 4K: 1*DVB-S2X + 1*DVB-C/T/T2
Posted 20 December 2021 - 15:43
If you want to step up a bit there is Edision MIO 4K+, main weakness is its remote control. Otherwise receiver is very good.
also nice but dont have gigabit port
Why do you need gigabit port???
Edited by twol, 20 December 2021 - 15:45.
Gigablue Quad 4K & UE 4K, Vu+Uno4KSE, DM900
.........FBC Tuners:
------------------> GT-SAT unicable lnb to 1.5M dish(28.2E)
------------------> Gigablue unicable lnb to 80 cm dish(19.2E)
Octagon sf8008, AX HD61, Edision Osmio 4K+, Zgemma H9Combo using Legacy ports on multiswitches
Zgemma H9twin & Zgemma H9 C/S mode into Giga4K
Posted 21 December 2021 - 10:45
so is 1gb ram still more then sufficient these days for iptv apps etc?
Yes .... Kodi is the big user
That is why I also asked about gigabit requirement, because for streaming unless you are streaming an uncompressed BluRay disc you are unlikely to need more than 100 megabits per second (and that's from readings on a bunch of media streamers over the years)
Gigablue Quad 4K & UE 4K, Vu+Uno4KSE, DM900
.........FBC Tuners:
------------------> GT-SAT unicable lnb to 1.5M dish(28.2E)
------------------> Gigablue unicable lnb to 80 cm dish(19.2E)
Octagon sf8008, AX HD61, Edision Osmio 4K+, Zgemma H9Combo using Legacy ports on multiswitches
Zgemma H9twin & Zgemma H9 C/S mode into Giga4K
Posted 21 December 2021 - 22:57
so is 1gb ram still more then sufficient these days for iptv apps etc?
Yes .... Kodi is the big user
That is why I also asked about gigabit requirement, because for streaming unless you are streaming an uncompressed BluRay disc you are unlikely to need more than 100 megabits per second (and that's from readings on a bunch of media streamers over the years)
you mean 1gb ram is still sufficient or better 2gb ram these days
Posted 22 December 2021 - 15:06
If it is to run Kody purchase a cheap Android TV box and this will does the trick, a STB is always a poor mediaplayer compared to any Android box.
NO SUPPORT by PM, it is a forum make your question public so everybody can benefit from the question/answer.
If you think that my answer helps you, you can press the up arrow in bottom right of the answer.
Wanna help with OpenPLi Translation? Please read our Wiki Information for translators
Sat: Hotbird 13.0E, Astra 19.2E, Eutelsat5A 5.0W
VU+ Solo 4K: 2*DVB-S2 + 2*DVB-C/T/T2 (used in DVB-C) & Duo 4K: 2*DVB-S2X + DVB-C (FBC)
AB-Com: PULSe 4K 1*DVB-S2X (+ DVB-C/T/T2)
Edision OS Mio 4K: 1*DVB-S2X + 1*DVB-C/T/T2
Posted 22 December 2021 - 15:50
DM920UHD DVB-S2X TRIPLE tuner + Triple M.S tuner DVB-S2X, DVB-T2/T, QboxHD, QboxHD Mini, Icecrypt T2300HD,
Qviart Lunix3 4K, Raspberry Pi 4 Model B 4GB & 8GB
Vertex 4K60 4:4:4 600MHz
Posted 22 December 2021 - 23:13
Go for HiSilicon box because it has better codec support than Broadcom.
Edited by Pr2, 22 December 2021 - 23:14.
NO SUPPORT by PM, it is a forum make your question public so everybody can benefit from the question/answer.
If you think that my answer helps you, you can press the up arrow in bottom right of the answer.
Wanna help with OpenPLi Translation? Please read our Wiki Information for translators
Sat: Hotbird 13.0E, Astra 19.2E, Eutelsat5A 5.0W
VU+ Solo 4K: 2*DVB-S2 + 2*DVB-C/T/T2 (used in DVB-C) & Duo 4K: 2*DVB-S2X + DVB-C (FBC)
AB-Com: PULSe 4K 1*DVB-S2X (+ DVB-C/T/T2)
Edision OS Mio 4K: 1*DVB-S2X + 1*DVB-C/T/T2
Posted 25 December 2021 - 04:15
Look for a GigaBlue UHD UE 4K
+ internal HDD 2,5"
+ Gigabit LAN Port
+ 2x DVB-S2x FBC Tuner
+ Fast processor with 2GB DDR4 RAM
+ 4GB eMMC Flash
this one support 4K in H.264 ?
i see its double price of sf8008 so whats better 2gb ram fbc tuner anything else?
Edited by speed, 25 December 2021 - 04:18.
0 members, 7 guests, 0 anonymous users