Blaster

after updating  6.1 to 6.2 

my boxes

Duo2 

Uno 4k Se

Solo 4k 

working fine no issue at all  @ 8 Pin diseq 

 

Did u try  Opkg upgrade via telnet ?

Yes, tested already + a lots of other things. I have finally found the problem now. It was actually the Spaun diseqc! Only a half years old. Unbelievable. So new that I did not suspect it at first. Running without it know, and everything works perfect and more smooth. Replacement diseqc on it's way. Hope it will work longer than this. Wierd case. Has Spaun became crap? Or just me very unlucky getting a bad one, bad batch or something? Anyone experience?

Hmm wierd. Are you using latest 6.2 too? I'll investige further. But it's so strange it happend right after upgrade if it's something else, but I'm going to check everything here.

Thanks. But not possible, soon as I connect the faulty LNB to the diseqc now, everything stops working. When I unplug it, everything works perfect (except this one faulty LNB of course). Must be some kind of a shortcut inside that LNB I think. I need a new one. Looking at Megasat LNB's. But not sure what's good and reliable LNB's this days. Any suggestions or experiences?

I was finally able to figure out it was a LNB problem. A connector on the LNB that was connected to the diseqc actually shortcut everything now and then. Tested the other  connectors on the same LNB (quad), works a while, then not. When unplugging this LNB everything works fine   So I guess it's water trapped inside or something. Problem finally figured out. Now I need to buy new LNB's. Think it's the best to replace them all. Any suggestions? Megasat ones good and reliable?