waara

I have been using OpenPli 6.1 in a VU+ Duo since a couple of months. Works perfectly.
Recently (some five days ago) i made a small change in the Audio settings. I changed AC3 and AAC downmixing to off (both were on) in order to get 5.1 surround in my SONOS surround system instead of downmixed Stereo.

Initially it worked perfectly, but the next day when I switched on the VU+ I noticed that the sound was gone. Dead silence on ALL Sat-channels. I spent some four hours trouble shooting with no success. Reboot, etc etc.
By mistake I unplugged the HDMI (coming from the VU+) from the TV. When I reinstalled the connector the sound kicked in. Worked as a charm until the next day, when it all started over again. Same fix.

The only thing I've changed are the two settings as above. Has anyone seen this? Is there a work around (other than reverting the downmixing back to were it was before)

Bet regards and cheers!

Roger

The combo is not working. I'm using OpenPli 6.1 at the moment without any problems. Yesterday I made a backup of my 6.1 installation, and after this tried to install 6.2. The installation went well, but I immedeately noticed that the only softcam installed was Mgcamd. I tried then to install CCCam 230. I got a lot of errors, and basically, the installation didn't work.

I tried installing 232 after this. The same problems.

I had to move back to OpenPli 6.1.

Anyone had the same problems? How do I fix this?

I have a VU+ Duo.

Best regards

Roger